Install punch tool for firming & closing pivot kits
LEGACY P/N WAS ARI 002 – Installation tool for firming/closing arm kits
You may also like…
-
$45.00
Removal tool for firming & closing kits
-
$45.00Chromed sleeve, bushings, and seals for firming arm's pivot, JD 750 & 1850 drills (doesn't fit the earliest 750s). Chromed steel sleeve is 69mm version for the 750s and 1850s. Note: The 50-series firming arm has the pin welded into it—you'll need to cut this off of the arm and bore a hole in that spot for a 5/8" bolt.
-
$45.00
Chromed sleeve, bushings, and seals for firming arm's pivot, JD 60/90 drills. Chromed steel sleeve is 62mm length for 60/90-series. (The 50-series requires a different length of sleeve; see the kit ARI.NG69)
-
$48.00Sleeve, bushings & seals for closing arm's pivot, JD 50/60/90 drills (excluding earliest 750s). Chromed steel sleeve is 86mm long for 50/60/90s (doesn't fit the earliest 750s).
Related products
-
$80.20Kit-Removal Tool for Main-Pin Bushings, JD 50/60/90 drills, Air Hammer LEGACY P/N WAS ARI 003A - Updated Removal Tool for Main-Pin Bushings, JD 50/60/90 drills, Air Hammer
-
$1.68LEGACY P/N WAS ARI 007 - Flange Locknut and washer for firming pivot point
-
$44.00Bushings and pin for front/main pin (where opener attaches to rockshaft clamp), JD 50/60/90 drills.
-
$4.68Grade 8 washer (special ID) and grade 8 special flange locknut (smooth underside; no serrations) for closing arm pivot point, JD 50/60/90 drill. Corresponding OEM parts are only grade 5, and wear out fairly quickly, which creates side-play and lets the spring for the closing arm pop out of its setting too easily.
